linux 内核处理缺页异常函数：do_page_fault ，2.4.0版

关于内核地址空间如何和进程地址空间合在一起，下面函数能看出来。

---

/*
 * This routine handles page faults.  It determines the address,
 * and the problem, and then passes it off to one of the appropriate
 * routines.
 *
 * error_code:
 *	bit 0 == 0 means no page found, 1 means protection fault
 *	bit 1 == 0 means read, 1 means write
 *	bit 2 == 0 means kernel, 1 means user-mode
 */
asmlinkage void do_page_fault(struct pt_regs *regs, unsigned long error_code)
{
	struct task_struct *tsk;
	struct mm_struct *mm;
	struct vm_area_struct * vma;
	unsigned long address;
	unsigned long page;
	unsigned long fixup;
	int write;
	siginfo_t info;

	/* get the address */
	__asm__("movl %%cr2,%0":"=r" (address));

	tsk = current;

	/*
	 * We fault-in kernel-space virtual memory on-demand. The
	 * 'reference' page table is init_mm.pgd.
	 *
	 * NOTE! We MUST NOT take any locks for this case. We may
	 * be in an interrupt or a critical region, and should
	 * only copy the information from the master page table,
	 * nothing more.
	 */
	if (address >= TASK_SIZE)//关键地方就在这分叉了，如果是内核地址空间3G以上，那么···你懂的。
		goto vmalloc_fault;

	mm = tsk->mm;
	info.si_code = SEGV_MAPERR;
	/*
	 * If we're in an interrupt or have no user
	 * context, we must not take the fault..
	 */
	if (in_interrupt() || !mm)
		goto no_context;
	down(&mm->mmap_sem);
	vma = find_vma(mm, address);
	if (!vma)
		goto bad_area;
	if (vma->vm_start <= address)
		goto good_area;
	if (!(vma->vm_flags & VM_GROWSDOWN))
		goto bad_area;
	if (error_code & 4) {
		/*
		 * accessing the stack below %esp is always a bug.
		 * The "+ 32" is there due to some instructions (like
		 * pusha) doing post-decrement on the stack and that
		 * doesn't show up until later..
		 */
		if (address + 32 < regs->esp)
			goto bad_area;
	}
	if (expand_stack(vma, address))
		goto bad_area;
/*
 * Ok, we have a good vm_area for this memory access, so
 * we can handle it..
 */
good_area:
	info.si_code = SEGV_ACCERR;
	write = 0;
	switch (error_code & 3) {
		default:	/* 3: write, present */
#ifdef TEST_VERIFY_AREA
			if (regs->cs == KERNEL_CS)
				printk("WP fault at %08lx\n", regs->eip);
#endif
			/* fall through */
		case 2:		/* write, not present */
			if (!(vma->vm_flags & VM_WRITE))
				goto bad_area;
			write++;
			break;
		case 1:		/* read, present */
			goto bad_area;
		case 0:		/* read, not present */
			if (!(vma->vm_flags & (VM_READ | VM_EXEC)))
				goto bad_area;
	}

	/*
	 * If for any reason at all we couldn't handle the fault,
	 * make sure we exit gracefully rather than endlessly redo
	 * the fault.
	 */
	switch (handle_mm_fault(mm, vma, address, write)) {
	case 1:
		tsk->min_flt++;
		break;
	case 2:
		tsk->maj_flt++;
		break;
	case 0:
		goto do_sigbus;
	default:
		goto out_of_memory;
	}

	/*
	 * Did it hit the DOS screen memory VA from vm86 mode?
	 */
	if (regs->eflags & VM_MASK) {
		unsigned long bit = (address - 0xA0000) >> PAGE_SHIFT;
		if (bit < 32)
			tsk->thread.screen_bitmap |= 1 << bit;
	}
	up(&mm->mmap_sem);
	return;

/*
 * Something tried to access memory that isn't in our memory map..
 * Fix it, but check if it's kernel or user first..
 */
bad_area:
	up(&mm->mmap_sem);

bad_area_nosemaphore:
	/* User mode accesses just cause a SIGSEGV */
	if (error_code & 4) {
		tsk->thread.cr2 = address;
		tsk->thread.error_code = error_code;
		tsk->thread.trap_no = 14;
		info.si_signo = SIGSEGV;
		info.si_errno = 0;
		/* info.si_code has been set above */
		info.si_addr = (void *)address;
		force_sig_info(SIGSEGV, &info, tsk);
		return;
	}

	/*
	 * Pentium F0 0F C7 C8 bug workaround.
	 */
	if (boot_cpu_data.f00f_bug) {
		unsigned long nr;
		
		nr = (address - idt) >> 3;

		if (nr == 6) {
			do_invalid_op(regs, 0);
			return;
		}
	}

no_context:
	/* Are we prepared to handle this kernel fault?  */
	if ((fixup = search_exception_table(regs->eip)) != 0) {
		regs->eip = fixup;
		return;
	}

/*
 * Oops. The kernel tried to access some bad page. We'll have to
 * terminate things with extreme prejudice.
 */

	bust_spinlocks();

	if (address < PAGE_SIZE)
		printk(KERN_ALERT "Unable to handle kernel NULL pointer dereference");
	else
		printk(KERN_ALERT "Unable to handle kernel paging request");
	printk(" at virtual address %08lx\n",address);
	printk(" printing eip:\n");
	printk("%08lx\n", regs->eip);
	asm("movl %%cr3,%0":"=r" (page));
	page = ((unsigned long *) __va(page))[address >> 22];
	printk(KERN_ALERT "*pde = %08lx\n", page);
	if (page & 1) {
		page &= PAGE_MASK;
		address &= 0x003ff000;
		page = ((unsigned long *) __va(page))[address >> PAGE_SHIFT];
		printk(KERN_ALERT "*pte = %08lx\n", page);
	}
	die("Oops", regs, error_code);
	do_exit(SIGKILL);

/*
 * We ran out of memory, or some other thing happened to us that made
 * us unable to handle the page fault gracefully.
 */
out_of_memory:
	up(&mm->mmap_sem);
	printk("VM: killing process %s\n", tsk->comm);
	if (error_code & 4)
		do_exit(SIGKILL);
	goto no_context;

do_sigbus:
	up(&mm->mmap_sem);

	/*
	 * Send a sigbus, regardless of whether we were in kernel
	 * or user mode.
	 */
	tsk->thread.cr2 = address;
	tsk->thread.error_code = error_code;
	tsk->thread.trap_no = 14;
	info.si_code = SIGBUS;
	info.si_errno = 0;
	info.si_code = BUS_ADRERR;
	info.si_addr = (void *)address;
	force_sig_info(SIGBUS, &info, tsk);

	/* Kernel mode? Handle exceptions or die */
	if (!(error_code & 4))
		goto no_context;
	return;

vmalloc_fault://下面就是如何处理内核地址空间的问题了。这里实现内核全局页目录表和进程页目录表同步
	{
		/*
		 * Synchronize this task's top level page-table
		 * with the 'reference' page table.
		 */
		int offset = __pgd_offset(address);
		pgd_t *pgd, *pgd_k;
		pmd_t *pmd, *pmd_k;
		pgd = tsk->active_mm->pgd + offset;
		pgd_k = init_mm.pgd + offset;
		if (!pgd_present(*pgd)) {
			if (!pgd_present(*pgd_k))
				goto bad_area_nosemaphore;
			set_pgd(pgd, *pgd_k);
			return;
		}
		pmd = pmd_offset(pgd, address);
		pmd_k = pmd_offset(pgd_k, address);
		if (pmd_present(*pmd) || !pmd_present(*pmd_k))
			goto bad_area_nosemaphore;
		set_pmd(pmd, *pmd_k);
		return;
	}
}